Transloetje Repair

BATTERY REPLACEMENT

1. Place the lamp upside down.
2. Loosen the 2 screws on the bottom plate.
3. Pull the 3 pins loose with the help of a pair of pliers.
4. Remove the base plate (make sure you keep the screws). 
5. Carefully open the silver box. 
6. Remove and disconnect the battery.
7. Insert and connect the new battery.
8. Carefully close the silver box. Make sure that no cables are trapped. 
9. Place the silver box back on the base plate. Make sure that the USB output is aligned with the base plate. 
10. Replace the screws and tighten them. 
11. Put the bottom plate back and make sure the holes of the pins are aligned.
12. Press the 3 pins back into place 
13. Connect the lamp to the charger to get it out of transport mode. 
14. You can use the lamp again.

REPLACING THE MOTHERBOARD

ONLY SUITABLE FOR TRANSLOETJE WITH USB-C CONNECTOR.

1. Place the lamp upside down.
2. Loosen the 2 screws on the bottom plate.
3. Pull the 3 pins loose with the help of a pair of pliers.
4. Remove the base plate (make sure you keep the screws). 
5. Carefully open the silver box. 
6. Remove and disconnect the battery.
7. Disconnect the plug from the mainboard.
8. Remove the silver plate.
9. Attach the new PCB to the silver plate.
10. Connect the new mainboard. 
11. Insert and connect the battery.  
12. Carefully close the silver box. Make sure that no cables are trapped. 
13. Place the silver box back on the base plate. Make sure that the USB output is aligned with the base plate. 
14. Replace the screws and tighten them. 
15. Put the bottom plate back and make sure the holes of the pins are aligned.
16. Press the 3 pins back into place
17. Connect the lamp to the charger to get it out of transport mode. 
18. You can use the lamp again.

REPLACING PINS

1. Carefully pull out the damaged pins with a pair of pliers 
2. Press the new pins into the openings provided. 
3. You can use the lamp again.